Connecting The Psd-3000U Drive Bay To The Sx-3000 - GDC SX-3000 Installation Manual

6.3

Connecting the PSD-3000U drive bay to the SX-3000

Note: On the bay PSD-3000U unit there are 3 hard drive bays and 3 SATA connectors. The Hard
drive bay front number corresponds with the SATA port (Figure 15) on the back of the unit.
To connect the PSD-3000U to the SX-3000, please use the following instructions.
1. Connect SATA ports 1, 2, and 3 on the back of the PSD-3000U to the eSATA
ports 1-3 on the SX-3000.
Figure 15 SATA ports of the PSD-3000U
2. Plug in the power supply and connect to the back of the PSD-3000M.
Figure 17 PSD–3000M Power Supply Plug
4. Power on the unit with the switch in the front left. (Figure 18). Then power on
the projector with SX-3000 before moving on to the next steps.
Important Note: Always power on the PSD-3000U external hard drive bay before powering up
the projector.
SX-3000 Installation Manual
Page 10 of 43
Figure 16 eSATA ports of the SX-3000
Figure 18 PSD–3000M Power Supply Plug