GDC SX-3000 Installation Manual page 36

8. Click [OK] and set up the device parameters for the eCNA device.
9. Enter the IP address of the eCNA device (see Figure 52).
10. The eCNA device has many cues available for automation. These cues can be enabled or
disabled by selecting them after clicking the [Server events], [eCNA controls], and [eCNA
status] buttons. All cues are disabled by default.
11. Click the [Save] button to save configured settings.
Figure 53 Automation settings for eCNA device
SX-3000 Installation Manual
Figure 52 eCNA automation device setup
Page 35 of 43