Front Panel Display; Rear Panel Layout - Cablescan 512 Instruction Manual

Continuity tester

Hide thumbs

Table Of Contents

Table of Contents

Model 512 Instruction Manual

The Model 512 employs a 40-character alphanumeric vacuum fluorescent display. The display

provides the user with test conditions, and error information. During Test the display provides

data in four fields: CONDITION, FROM POINT, TO POINT, and CIRCUIT LABELS. All four

fields use alphanumeric characters.

OPEN

JA-1

REAR PANEL LAYOUT

The rear panel contains a power switch; an AC receptacle for line power connection; a power

fuse; Footswitch connector; Probe connector for either a probe or wrist strap; an external speaker

connector, an Enable receptacle; a serial port connector for a printer, and a serial port for a

terminal or personal computer (PC). Test points are provided on the rear panel through eight

64-pin connectors (J1 through J8).

A wrist-strap kit provides the capability to locate wires by touch during assembly and

troubleshooting, utilizing body conductance. A probe provided in the kit may also be used.

A foot switch is provided for advancing through the test and assembly modes, or restarting the

test mode.

An optional 80-column serial printer provides hard copies of error lists, wire lists, and user label

lists. Refer to Printer Setup instructions in the System Setup section.

FOOTSWITCH

511

512

383

384

255

256

127

128