Cablescan 512 Instruction Manual page 60

Model 512 Instruction Manual Page 51
Find Wire Number - FW XXX
This command is used only in the Wire List Table to find a specific wire number (circuit label).
This command locates a string of characters that have been assigned in the circuit label field. If
the FW command is entered without a circuit label, the last circuit label entered with the FW
command will be searched. Search is started from the cursor position to the end of the table. To
search the entire table, back the cursor to the start of the table by entering FS 1 followed with an
ENTER. Consecutive FW commands will find every occurrence of the circuit label string in the
table. If the string is not found between the cursor and the end of table, the display will read
NOT FOUND.
Sort Tables - SO
Whenever a change is made to the Wire List Table, a sort operation must be done before a Test
or a Record can take place. This is done automatically by the system. At times you may see
SORTING PT-PT TABLE when you press TEST or RECORD. If the table has not been sorted,
an automatic sort will take place. This table is stored in ascending order and cannot be edited by
the user. By entering the print command PS, a list of this table can be printed. This printout will
also group all multiple circuits.