Table of Contents
Advertisement
Model 512 Instruction Manual
Delete - D[d] [filename]
Deletes a wire list program specified by [filename] from the disk drive specified by [d]. To
delete program PN943 from the internal 3.5" drive, enter:
Initialize - I[d]
This command initializes the diskette in the specified drive. All diskettes must be initialized
before any information can be stored on them. Initialization will destroy any information on the
diskette. After the command is entered, a question will ask if you are sure this is what you want
to do. If you entered the instruction by mistake, type an N. If you want to execute this
command, enter a Y. To format the diskette in the internal 3.5" drive, type I followed by an
ENTER
Load - L[d] [filename]
Loads a program specified by [filename] from the floppy disk specified by [d]. To load program
PN943 from the internal 3.5" drive into memory, enter:
Replace - R[d] [filename]
Replaces an existing wire list program saved on the disk drive specified by [d] with the program
in memory. This command is used when the file name already exists on the specified drive.
(Use the Save command when writing a program to a new file name.) To replace the existing
program PN943 that is on the internal 3.5" drive with the program in memory enter:
Save - S[d] [filename]
Saves (writes) a wire list program from Model 512 memory to the disk drive specified by [d]
with the name specified by [filename]. The file name must not already exist on the disk. (Use
the Replace command to save to an existing filename.) To save the program in memory and
assign it file name PN943 on the internal 3.5" drive, enter:
Rename - Z[d]
This command renames an existing wire list program on disk drive specified by [d]. The system
prompts for the "Old name" first. Type the name of the program to rename; the system then
prompts for the "New Name."
D PN943
L0 PN943 or
L PN943
R PN943
S PN943
Page 34
Advertisement
Table of Contents
