Disk Commands - Cablescan 512 Instruction Manual

Model 512 Instruction Manual

DISK COMMANDS

The following commands provide control over the disk drive in loading and saving programs,
deleting and replacing programs, and initializing (formatting) new diskettes. New diskettes must
first be initialized before programs can be stored on them. Disk commands are single-letter
entries followed with a disk drive number (0 or 1) and a file name if required. Drive 0 (internal
drive) is used if the drive number is omitted. In the following paragraphs, [d] represents the
drive number, 0 or 1, and the [filename] is the name of the program to use with the function.
File names are 1-8 characters in length.
Tester Function
Directory 0
Directory 1
(not available)
(not available)
Format Drive 0
Format Drive 1
(Directory 0)
(Directory 1)
(not available)
(not available)
Save Program
Save Program
(not available)
(not available)
A floppy disk must first be formatted with the Initialize command
before a program can be saved. Use only double-sided, double-
density diskettes (3.5"-2DD).
density diskettes (3.5"-HD).
Catalog - C[d]
This command lists the names of all the programs on the specified disk drive. It also displays the
length of each program, and the last date the program was modified. To list the programs on the
internal 3.5" drive, type C followed by an ENTER.
2-letter Include File
Command Name
C0 no
C1 no
D0 yes
D1 yes
I0 no
I1 no
L0 yes
L1 yes
R0 yes
R1 yes
S0 yes
S1 yes
Z0
Z1
NOTE
Errors may occur using high-
Command
Description
Catalog Drive 0
Catalog Drive 1
Delete from Drive 0
Delete from Drive 1
Initialize Drive 0
Initialize Drive 1
Load from Drive 0
Load from Drive 1
Replace to Drive 0
Replace to Drive 1
Save to Drive 0
Save to Drive 1
Rename on Drive 0
Rename on Drive 1
Page 33