Table of Contents
Advertisement
Pronar T400
5.6.2
LIGHT BULBS REPLACEMENT
Light bulb list is presented in table (5.3). All lampshades of lighting lamps are mounted with
screws and there is no need to disassemble the entire lamp or trailer components.
Table 5.3
Light bulb list
LIGHT BULB
Rear left grouped lamp
Rear right grouped lamp
Front position lamp
End-outline lamp
5.7 LUBRICATION
The trailer should be lubricated with a hand or foot grease gun, filled with the recommended
lubricant. If possible, remove old grease and other contaminants before starting work. After
finishing work, wipe off excess grease.
Parts that should be lubricated using machine oil should be wiped with a dry clean cloth, and
then the lubricated surfaces oiled with a small amount of oil (with oiler or brush). Wipe off
excess oil.
The replacement of grease in wheel axle hub bearings should be entrusted to specialized
service points equipped with the appropriate tools. In accordance with the recommendations
of the axle manufacturer, disassemble the entire hub, remove the bearings and individual
sealing rings. After thorough cleaning and inspection, install lubricated components. If
necessary, bearings and seals should be replaced. Lubrication of axle bearings should be
carried out at least once every 2 years or after covering 50,000 km. In the event of intensive
use, this should be done more often.
Empty containers after grease or oil should be disposed of in accordance with the lubricant
manufacturer's instructions.
Table 5.4
Lubrication schedule
LIGHT BULB / QUANTITY IN
LAMP TYPE
WE 549L
WE 549P
LO-110PP
127 021 00 00
5.30
ONE LAMP
R10W / 1 pcs.
P21W / 2 pcs.
R10W / 1 pcs.
P21W / 2 pcs.
C5W / 1 pcs.
R5W / 1 pcs.
CHAPTER 5
LAMP
QUANTITY
1
1
2
2
Advertisement
Table of Contents
