Table of Contents
Advertisement
CHAPTER 5
5.3.7 REPLACING PNEUMATIC LINES
Permanently deformed, cut or frayed pneumatic lines qualify only for replacement.
The scope of service activities
Completely reduce system pressure.
Remove the pneumatic conduit by unscrewing the nut (2).
Figure 5.10
Pneumatic conduit installation
(1) pneumatic conduit, (2) connection nut, (3) cutting ring, (4) reinforcing sleeve
Insert new cable.
Pressure reduction can be achieved by repealing the drain valve stem.
The inside of the pneumatic conduit should be clean.
The ends of the pneumatic conduit (1) must be cut at right angles.
The cutting ring (3) should be fitted as on drawing (5.10).
The reinforcing sleeve (4) of the conduit must be pressed in
thoroughly.
5.23
Pronar T400
Advertisement
Table of Contents
