Table of Contents
Advertisement
Pronar T400
FAULT
Damage to the PTO shaft
Chain conveyor control
does not work
CAUSE
Tailgate closed or not open
sufficiently
Damaged chain
transmission or insufficient
chain tension. Tensioner
springs damaged.
Too large angular deflection
during operation.
PTO shaft too short or too
long
Oil flow interrupted.
Mixed-up supply hoses
5.48
REMOVAL METHOD
Check the correct opening of the
tailgate.
Open the covers and check the
condition and tension of the
transmission chains.
Use a wide-angle shaft or
disconnect the PTO when
cornering.
Change the PTO shaft.
Adjust the shaft according to the
instructions in the manual
provided by the shaft
manufacturer
Check the degree of wear of the
connector plug.
Set the tractor's control valve to
pressure.
Correct the connection.
CHAPTER 5
Advertisement
Table of Contents
