Support Foot Handling - PRONAR T400 Operator's Manual

CHAPTER 4
Connect the yellow pneumatic conduit.
Connect the red pneumatic conduit.
Connect the lighting and signaling installation electrical cable.
Connect the red hydraulic hoses of the conveyor mechanism.
Connect the black hydraulic hoses of the tailgate system.
Connect the blue hydraulic hose of the steering lock system.
Connect the hydraulic hoses of the front tilting extension.
Connect the PTO shaft.
ATTENTION
The trailer may be aggregated only with a tractor that meets the requirements related to
the minimum power demand, has the appropriate connection sockets for the braking and
hydraulic system, the hydraulic oil in both machines is of the same grade and the tractor
hitch can withstand the vertical load of the loaded trailer's drawbar. Check that the tractor
PTO shaft corresponds to the trailer manufacturer's requirements. Check shaft rotation
direction.
After completing aggregation, secure the hydraulic, braking and electrical wiring in such a
way that they do not get pulled in by the moving parts of the tractor during travel and are
not exposed to breakage or cutting when turning.
When connecting the control lines for the operation of individual hydraulic circuits, make
sure that the corresponding pairs of lines are not mixed up. The cables are marked with
information labels.

4.3.1 SUPPORT FOOT HANDLING

Setting the correct height of the drawbar eye relative to the tractor's hitch is obtained by using
a support with a mechanical gear - figure (4.1).
Raising the support
Remove safety pin (3).
Push the foot (2) into the support body.
Reinsert the locking pin.
Turn the crank counterclockwise to raise the support foot (2) as much as
possible.
4.7
Pronar T400