Cab Preparation And Wiring - Non-Hawkeye® Machines Only; Chassis Cable Routing And Connection; Best Practices And Recommendations; Cab Connections - Raven Hawkeye 2 Installation Manual

CHAPTER
6
NOTE: This chapter is only needed for machines that did not previously have Hawkeye® Product Control
installed. This chapter will require CAN Product Control to ISO Upgrade Kit (P/N 117-2005-005).

CHASSIS CABLE ROUTING AND CONNECTION

BEST PRACTICES AND RECOMMENDATIONS

• Do not connect battery leads until all cables are installed and connected.
• Route chassis cabling along existing cabling or plumbing to help avoid pinch points or stretching the cable
during normal equipment operation.

CAB CONNECTIONS

FOR CLASS 3XX0 MACHINES
1. Remove the packing net located near the floor at the back of the cab.
FIGURE 1. Packing Net
Back of Cab
Packing Net
2. Take off the wing nuts securing the SmarTrax node and mounting plate (if applicable) to the back of the cab.
Cab Preparation and Wiring - Non-Hawkeye® Machines Only: Chassis Cable Routing and Connection
C AB PREPARATION AND
C H A P T E R 6
WIRING - NON-HAWKEYE®
MACHINES ONLY
27