Raven Hawkeye 2 Installation Manual page 26

CHAPTER 5
6. Connect the left and right inner boom cables that were routed towards the center rack in Chapter 4, Hawkeye®
2 NCV and Boom Cable Installation, to the two round mating connections on the Hawkeye® 2 RCM - Sprayer
cable (P/N 115-2005-027).
FIGURE 9. Boom Cable Connections
Right Boom
Connection
NOTE: Observe the left and right connector ID tags on the cable.
7. Locate the two 12-pin mini Deutsch receptacles, labeled "Flow/Pressure" and "Valve," on the Hawkeye® 2 RCM
- Sprayer harness (115-2005-027) and route them over the center rack and along the left frame rail towards the
cab.
NOTE: Follow existing cables and power wires.
8. Locate and disconnect the existing black and gray single product node connections along the left frame rail. If
Hawkeye® was previously installed, these would have been connected to the Hawkeye® ECU harness
previously removed.
9. Connect the 12-pin mini-Deutsch receptacles of the Hawkeye® 2 RCM - Sprayer harness (P/N 115-2005-027) to
the gray and black plugs along the left frame rail.
FIGURE 10. 12-Pin Mini Receptacles
Black,
Labeled
"Flow/
Pressure"
Gray,
Labeled
"Valve"
22 Hawkeye® 2 Installation Manual for Case IH Patriot (MY 2009-2016)
Left Boom
Connection
From
Single
Product
Node