Chapter 6 Cab Preparation And Wiring; Chassis Cable Routing And Connection; Best Practices And Recommendations; Isobus Cable Cab Preparation - Raven Hawkeye Installation Manual

CHAPTER
6

CHASSIS CABLE ROUTING AND CONNECTION

BEST PRACTICES AND RECOMMENDATIONS

• Do not connect battery leads until all cables are installed and connected.
• Route chassis cabling along existing cabling or plumbing to help avoid pinch points or stretching the cable
during normal equipment operation.

ISOBUS CABLE CAB PREPARATION

1. While sitting in the drivers seat, look towards the floor on the lower right rear corner of the cab and locate the
covers over the electrical box.
2. Remove the plastic cover from the electrical box.
3. Remove the fastener from the electrical panel and fold the panel down.
4. Locate the existing boom sense/speed node mounted to the back wall inside the electrical box.
5. Remove the existing boom sense/speed node connections from the node by squeezing the clips on the sides
of the connection and pulling down.
6. Remove the two bolts securing the boom sense/speed node. Keep the hardware for later use.
7. Locate an available knockout in the cab floor.
FIGURE 1. Knockouts in Cab
Manual No. 016-0171-587 Rev. C
C AB PREPARATION AND
C H A P T E R 6
WIRING
Center
Knockout
Boom Sense/Speed
Node
25