Cab Preparation And Wiring; Console Cable Routing And Connection; Best Practices And Recommendations; Viper 4 And Console Cable Connections - Raven Hagie Hawkeye STS Installation Manual

CHAPTER
6

CONSOLE CABLE ROUTING AND CONNECTION

BEST PRACTICES AND RECOMMENDATIONS

• Do not connect battery leads until all cables are installed and connected.
• Route console cabling along existing cabling or plumbing to help avoid pinch points or stretching the cable
during normal equipment operation.

VIPER 4 AND CONSOLE CABLE CONNECTIONS

1. Start the machine and, using the hydraulic controls, completely extend the front right axle out to gain access to
the exterior cab panel.
2. Remove the exterior cab panel. Refer to Figure 1, "Exterior Cab Access Panel Removed,".
FIGURE 1. Exterior Cab Access Panel Removed
Cab Access
Panel
3. In the cab, locate and remote the access panel in the front right corner.
P/N 016-0171-635 Rev. C
C AB PREPARATION AND
C H A P T E R 6
WIRING
19