Raven Hawkeye 2 Installation Manual page 33

7. Locate the boom sense node.
FIGURE 4. Boom Sense Node
Back of Cab
8. Remove the two nuts that secure the boom sense node to the back of the cab.
9. Install the new ISO boom sense node to the location the original boom sense node was mounted.
10. Disconnect gray connector from the original boom sense node and install it in the top gray connector on the
new ISO boom sense node.
11. Disconnect the black plug from the original boom sense node. This will not be used for the Hawkeye® 2
installation.
12. Connect the black 12-pin connector on the 115-7303-115 cable and connect it to the bottom black connector of
the new ISO sense node.
13. Route the round black seven pin plug on the 115-7303-115 to the back of the Viper 4 and connect it to port 5.
14. Locate the cable feed through in the back cab window.
FIGURE 5. Feed Through in Back Window
Back
Window
Feed
Through
Cab Preparation and Wiring - Non-Hawkeye® Machines Only: Chassis Cable Routing and Connection
CAB PREPARATION AND WIRING - NON-HAWKEYE® MACHINES ONLY
Boom Sense
Node
To Viper 4
29