Chapter 5 Rcm - Sprayer Mounting And Connection; Rcm - Sprayer Installation; Best Practices And Recommendations; Mounting Plate Preparation - Raven Hawkeye 2 Installation Manual

CHAPTER
5

RCM - SPRAYER INSTALLATION

BEST PRACTICES AND RECOMMENDATIONS

• Do not connect battery leads until all cables are installed and connected.
• If a protected mounting location is not available on the equipment, mount the Hawkeye® 2 RCM - Sprayer
with the connectors facing down toward the ground to help keep moisture from accumulating in the electrical
connections.

MOUNTING PLATE PREPARATION

NOTE: If Hawkeye® is already installed on this sprayer, skip step 1 through step 4 and begin with step 5.
FIGURE 1. AccuBoom Node
1. Locate the existing AccuBoom node mounted to the center rack of the boom.
2. Use a socket to remove the three bolts that secure the existing AccuBoom node to the mounting plate.
3. Disconnect and remove the AccuBoom node harness.
4. Remove the two U-bolts securing the AccuBoom plate to the frame.
5. Locate the following items to mount the RCM - Sprayer:
•
RCM - Sprayer Mounting Bracket
•
3/8" U-Bolts and Nuts
•
M6 Hex Bolts, Washers, and Nuts
•
RCM - Sprayer
RCM - Sprayer Mounting and Connection: RCM - Sprayer Installation
R CM - SPRAYER MOUNTING
C H A P T E R 5
AND CONNECTION
AccuBoom Node
17