Raven Hawkeye 2 Installation Manual page 34

Hide thumbs Also See for Hawkeye 2:

Table of Contents

CHAPTER 6

15. Route the four-pin can connector out of the cab towards the rear of the sprayer. This will connect to the RCM -

Sprayer cable (115-2005-027).

16. Reinstall the back panel, cover, SmarTrax node (if applicable) and package net.

FOR CLASS 4XX0 MACHINES

1. Lift the instructional seat cushion and remove any contents.

FIGURE 6. Instruction Seat

2. Remove the plastic compartment.

3. Locate the boom speed node near the back wall of the cab.

FIGURE 7. Boom Speed Node

Boom Speed

Node

4. Install the new ISO boom sense node to the location the original boom sense node was mounted.

5. Disconnect gray connector from the original boom sense node and install it in the gray receptacle on the new

ISO boom sense node.

6. Disconnect the black plug from the original boom sense node. This will not be used with the Hawkeye® 2

installation.

7. Locate the black 12-pin connector on the 115-7303-115 cable and connect it to the black receptacle on the new

ISO boom sense node.

Hawkeye® 2 Installation Manual for Case IH Patriot (MY 2009-2016)

Instruction

Seat

Table of Contents