Assemble The Mounting Brackets; Prepare The Roof - Raven RS1 Installation Manual

With direcsteer

Hide thumbs Also See for RS1:

Table of Contents

Assemble the Mounting Brackets

1. Use the supplied hardware to secure the RS1™ bottom bracket assembly (P/N 116-

0159-802) to the adhesive strips.

2. Mount the latch plate (P/N 107-0172-531) to the RS1™ using the provided screws.

Note:

The bottom mounting bracket will adhere to the roof of the tractor. The latch

plate stays mounted to the RS1™.

3. Secure the RS1™ latch plate to the fixed base plate using the latch.

1. Select a location on the cab roof to mount the RS1™. Consider all of the following

mounting requirements for best functionality of RS1™:

RS1™ must mounted at least 50 cm [20 in.] from other GNSS, cellular, or radio

antennas or equipment.

Align the RS1™ on the center line of the tractor in front of the rear axle or toward

the front of the cab.

RS1™ is mounted with the connectors facing toward the rear of the tractor.

2. Thoroughly clean the selected location.

Install RS1™ with DirecSteer

Table of Contents

Sc1