Table of Contents
Advertisement
CHAPTER
7
REMOVING EXISTING PRODUCT CONTROL ECU AND CABLE HARNESS
MODEL YEAR 2014-15 MACHINES
1. Extend the right rear axle of the machine to gain access to the Product Control ECU box.
2. Locate the Product Control ECU box just above the right rear axle.
FIGURE 1. Product Control ECU Box
3. Lift the cover and pull it away from the machine to remove the cover.
4. Using a 1/4" driver, remove the two electrical connectors from the Raven Multi-Product Node.
5. Remove the Multi-Product Node from the machine and set it aside. This is not needed for the Hawkeye system.
6. Follow the product control cable harness that was disconnected from the node and disconnect all control cable
harness connections from the machine.
7. Remove the harness. This is not needed for the Hawkeye system.
MODEL YEAR 2016-2017 MACHINES
1. Locate the Raven Multi-Product Node on the inside of the foremost skip plate on the underside of the machine.
P/N 016-0171-635 Rev. C
I SOBUS ECU MOUNTING AND
C H A P T E R 7
CONNECTION
25
Advertisement
Table of Contents
