CHAPTER
6
PRODUCT CONTROLLER II ECU INSTALLATION
BEST PRACTICES AND RECOMMENDATIONS
• Do not connect battery leads until all cables are installed and connected.
• If a protected mounting location is not available on the equipment, mount the Hawkeye product controller II
ECU with the connectors facing down toward the ground to help keep moisture from accumulating in the ECU.
ELECTRICAL BOX PREPARATION
1. Locate the electrical box on the right side of the machine, between the axles and remove the cover.
FIGURE 1. Electrical Box Location
Machine
Electrical Box
2. Locate the Raven single product control node mounted to the back of the box.
NOTE:
Due to harness differences, the Hawkeye Nozzle Control System is only compatible with machines
factory-equipped with Raven product control.
P/N 016-0171-640 Rev. A
I SOBUS ECU MOUNTING AND
C H A P T E R 6
CONNECTION
23