Start-Up And Operation - KEB COMBIVERT T6APD Instructions For Use Manual

bASIC SAfETY INSTRUCTIONS

1.6 Start-up and operation

The drive controller must not be started until it is determined that the installation com-
plies with the machine directive; Account is to be taken of
WARNING
The COMBIVERT T6
parameterization. The parameterization is carried out via a main controller (MCU), which
communicates with the individual axis controllers (DCUs). The main controller contains
additionally a freely programmable control unit where the customer can store software
related to his application (customer software). The customer software can already be
installed at KEB on request.
NOTICE
The T6
freely configured in many areas by the customer software and parameterization. The
writing of the customer software and the examination of the customer software for any
dangers, which could result from it, is the responsibility of the customer and is not owed
by KEB. For these reasons, KEB is not liable for the behavior of the CAN interfaces and
any resulting hazards or damages.
Software protection and programming !
Hazards caused by unintentional behavior of the drive!
► Check especially during initial start-up or replacement of the drive
controller if parameterization is compatible to application.
► Securing a unit solely with software-supported functions is not suf-
ficient. It is imperative to install external protective measures (e.g.
limit switch) that are independent of the drive controller.
► Secure motors against automatic restart.
system can be adapted to a wide variety of applications by
APD
Use of customer software in our devices!
► The use of customer software in the target products with regard to
location, purpose and application is outside our control and there-
fore lies exclusivelsy in the area of responsibility of the customer.
► Checks and tests can only be done in combination with the applica-
tion.
► Checks and tests have to be repeated if hardware, firmware, soft-
ware, device setting or only parts thereof are modified by KEB.
► The customer confirms with a release from liability the responsibility
for the customer software towards KEB.
system has two CAN interfaces whose parameters and behavior can be
APD
EN 60204-1.
19