Table of Contents Table of Contents Introduction ..................... 4 General ..........................4 Validity ..........................4 1.3 Qualification .........................5 Order data ..........................5 Product description ......................5 Hardware ......................6 Description of USB serial converter ..................6 Technical data ........................6 Software ......................7 Manual Driver Installation ....................8 Use among Combivis 5.6 ....................8 List of figures Figure 1:...
Introduction Introduction General Prior to performing any work on the unit the user must familiarize himself with the unit. This includes especially the knowledge and observance of the safety and warning directions. The pictographs used in this instruction manual have following meaning: Danger Refers to danger of life by electric current.
00F50C0-0020 Product description The USB serial converter is used for the connection of KEB inverters, operators or controls with DIN66019 interface or interface HSP5 at the USB port of personal computers. It repre- sents a virtual COM interface on PC side.
Hardware Hardware Description of USB serial converter The serial side supports: DIN66019 (RS 232)/HSP5 (TTL level) USB socket type B Figure 1: USB serial converter Technical data General Dimension (H x B x L) 20 mm x 35 mm x 88 mm Weight 30 g Ambient conditions during operation...
If the HSP5 protocol is used on the serial side, the "DIN66019 protocol USB" is converted to "HSP5 protocol TTL level" in the USB serial converter. The following KEB services are supported (see protocol description HSP5): Read / write the parameter value (extended set-addressing)
BIVIS 5 from the F5 when connected via HSP5. Use among Combivis 5.6 When using the USB serial converter KEB under COMBIVIS 5.6 some things to consider: The communication settings are run in serial protocol DIN 66019, even if the converter is con- nected to an interface of a HSP5 COMBIVERT F5 or COMBIVERT B6.
Software The configuration settings in COMBIVIS 5.6 can be reached under the menu bar Edit -> Con- figuration -> DIN 66019. Figure 2: Configuration In the menu item "Send single" remove the tick. The driver has to install manually, see chapter "Manual Driver Installation".Excep- tion:The driver has already been installed automatically by COMBIVIS 6.