M306NKT-EPB User's Manual
2.10.2 Pullup of Emulation Ports
Because this product emulates some I/O ports (P0 to P5, P10), you can not pullup ports P0 to P5 by the pullup control registers.
Install the included resistor arrays (51 kΩ) as necessary. Figure 2.17 shows the positions of the pullup resistors.
Figure 2.17 Positions of the pullup resistors
Table 2.1 Emulation ports and pullup resistor part numbers
Port
Resistor part
P00--P07
RM1 (51 kΩ pullup)
P10--P17
RM2 (51 kΩ pullup)
P20--P27
RM3 (51 kΩ pullup)
P30--P37
RM4 (51 kΩ pullup)
P40--P47
RM5 (51 kΩ pullup)
P50--P57
RM6 (51 kΩ pullup)
REJ10J0519-0200 Rev.2.00 Oct. 16, 2006
Component side of the M306NKT-EPBM
6NK
↑
Positions to install pullup resistor arrays
2. Setup
Page 41 of 104