Connecting To A 100-Pin 0.65Mm Pitch Foot Pattern (Part 2) - Renesas M16C/6N User Manual

M306NKT-EPB User's Manual

2.9.3 Connecting to a 100-pin 0.65mm Pitch Foot Pattern (Part 2)

Here following is a procedure of connecting to a 100-pin 0.65mm pitch foot pattern on the user system using the M3T-
DIRECT100S (not included). For details on the M3T-100LCC-DMS (not included) and M3T-DIRECT100S (not included),
refer to each user's manual.
(1) Attach the M3T-DIRECT100S to the user system.
(2) Attach the M3T-100LCC-DMS to the M3T-DIRECT100S.
(3) Attach the CN2 side of the M30800T-PTC to the J4 side of the M306NKT-EPB.
(4) Attach the M30800T-PTC to the M3T-100LCC-DMS.
Figure 2.11 Connecting to a 100-pin 0.65mm pitch foot pattern (Part 2)
Note on Connecting the User System:
Take care not to attach a converter board in a wrong direction. It may cause a fatal damage to the emulator and
user system.
Notes on Connectors of the Converter board:
The connectors of the M30800T-PTC are guaranteed for only 50 insertion/removal iterations.
The connectors of the M3T-100LCC-DMS and M3T-DIRECT100S are guaranteed for only 20
insertion/removal iterations.
REJ10J0519-0200 Rev.2.00 Oct. 16, 2006
M3T-FLX160-EPB
M306NKT-EPB
CN2 side
(3)
M30800T-PTC
M3T-100LCC-DMS
(not included)
(4)
M3T-DIRECT100S
(2)
(not included)
100-pin 0.65mm pitch
(PRQP0100JB-A) foot pattern
(1)
No. 1 pin
CAUTION
IMPORTANT
User system
2. Setup
Page 35 of 104