Method Of Making Mcu File (The 740 Debugger) - Renesas Emulator Debugger M16C PC4701 User Manual

5.6.2 Method of making MCU file (the 740 Debugger)

The following content is sequentially described in the MCU file.
Please describe information on 1-4 referring to the data book on MCU used.
1. Number of stack page selection bit
2. Address of CPU mode register
3. End address of stack*1
4. Address of reset vector
5. POD number*2
6. Firmware name
7. MCU Information No.*3
*1 End address of stack
Specify the last address of the area to be used as the stack. Consider the initial value of the stack
page selection bit in the CPU mode register. (The initial value of the stack page selection bit depends
on the microcomputer.) For a microcomputer which sets the stack page selection bit initial value to
"0", the allowable designation range is a 0 page address range (0h to FFh). For a microcomputer
which sets the stack page selection bit initial value to "1", the allowable designation range is a 1 page
address range (100h to 1FFh).
POD number
*2
Pod Name
M38000T-FPD
M38000TL-FPD
M38000TL2-FPD
M37207T-RPD
M37515T-RPD
M37610T-RPD
M37640T-RPD
M37690T-RPD
M38749T-RPD
MCU where emulator MCU does not exist is excluded.
*4
Target firmware name
Omit "u.s", "h.s", or "l.s", which mean types of emulators.
MCU Information No.
*3
Please describe the MCU information No. referring to the following tables.
POD No. Firmwa re
0 M38000
80 M38000
4 0 M38000
2 M37600
4 M37600
1 M37600
40 M38000
MCU Name
M3753x ,M 3754x
M376xx
Others
File Correspondence MCU
7200/7450/7470/38000/
7500Series(7507,7510,7515,7520 Group)
M37102,M37201,M372 2,M37204,M37207
7515/3850/3 51 Group 8
7610 Group
7640 Group
7690 Group
3874Group
M U Information No. C
01
02
00
57
5 Setup the Debugger
*4
0