Specify The Trace Write Condition; Command Button - Renesas Emulator Debugger M16C PC4701 User Manual

7.9.5 Specify the Trace Write Condition

Conditions for cycles to be written to trace memory can be specified.
Total Writes all cycles.
Pick up Writes only the cycles where specified condition holds true.
Exclude Writes only the cycles where specified condition does not hold true.
Also, following three write modes are supported.

7.9.6 Command Button

The buttons on this window has the following meanings.
Button
Reset
Save...
Load...
Set
Close
Only cycles where specified event is established
Cycles from where specified event is established
to where specified event is not established
Cycles from where start event is established to
where end event is established
Function
Discards the contents being displayed in the
window and loads contents from the simulator in
which they were set.
Saves the contents set in the window to a file.
Loads event information from a file in which it
was saved.
Sends the contents set in the window to the
simulator.
Closes the window.
153
7 Windows/Dialogs