11. Display the Cause of the Program Stoppage
If the program is stoped by the debug function, the cause of the stoppage is displayed in the Output
window or Status window ([Platform] sheet).
The contents of a display and the meaning of "the cause of the stoppage" are as follows.
Disp y
la
Halt
S/W break
Address match interrupt break
H/W event, Combination
H/W event, Combination, Ax
H/W event, State transition, from xx
H/W event, State transition, Timeout
H/W event, Access protect error
Note
To be able to show the cause of break or not depends on the connected target. Some targets may
always show "Halt" or show "---".
The cause of the stoppage
The stop by the [Halt Program] button/menu
Software break
Address interrupt break
Hardware break, logical combination AND or AND(same
time)condition was met
Hardware break, logical combination OR condition was
met
(Ax: The event number of which condition was met.)
Hardware break, State Transition condition was met
(from xx: previous state (start, state1, state2))
Hardware break, State Transition, Time Out condition was
met
Protect break
262