Table of Contents
Advertisement
M306NKT3-RPD-E User's Manual
3. Usage (How to Use the Emulator Debugger)
This chapter describes how to start up the M16C PC4701 emulator debugger from the High-performance Embedded Workshop
and how to use the main windows.
3.1. Making an MCU File
It is necessary to make an MCU file to use this product with the emulator debugger. According to the MCU you use, change
the contents of the MCU file. Make the MCU file named "M306NKT3.MCU" etc. following the description below using a text
editor and store it in the "mcufiles" folder in the directory where the emulator debugger is installed.
The emulator debugger has been installed in the following directory by default.
- When using the M16C PC4701 emulator debugger on the High-performance Embedded Workshop
C:\Program Files\Renesas\Hew\Tools\Renesas\DebugComp\Platform\PDTarget\PD30\McuFiles
- When using the M3T-PD30
C:\mtool\PD30\McuFiles
The MCU file contains information such as, SFR area, internal RAM area, internal ROM area, firmware file name. The
contents of the MCU file when using the M306NKFJGP (31KB RAM, 512KB ROM) are as follows:
0
3FF
400
7FFF
80000
FFFFF
M30620P : Name of firmware
0
The contents of the MCU file when using the M306N4FGTFP (10KB RAM, 256KB ROM) are as follows:
0
3FF
400
2BFF
C0000
FFFFF
M30620P : Name of firmware
0
When using this product in microprocessor mode, set the internal ROM area as follows.
00000
00001
REJ10J0326-0400 Rev.4.00 Sep. 01, 2006
: SFR area
Start address
:
End address
: Internal RAM
Start address
:
End address
: Internal ROM
Start address
:
End address
(Do not change.)
: Expansion No.
(Do not change.)
: SFR area
Start address
:
End address
: Internal RAM
Start address
:
End address
: Internal ROM
Start address
:
End address
(Do not change.)
: Expansion No.
(Do not change.)
: Internal ROM
Start address
:
End address
3. Usage (How to Use the Emulator Debugger)
Page 50 of 104
Advertisement
Table of Contents
