Procedure For Making Mcu File For M3T-Pd30 - Renesas M302N1 User Manual

3.5 Procedures for Making MCU File for M3T-PD30
It is necessary to change the contents of the MCU file according to the MCU to be developed. Make
the MCU file M302N1.MCU for M302N1 Group and M302N2.MCU for M302N2 Group and store
it in the following directory (the directory varies depending on the version of the M3T-PD30).
• M3T-PD30 Ver.5.00 or later: Store the MCU file in the "Mcufiles" folder in the directory same
• M3T-PD30 Ver.4.10 or earlier: Store the MCU file in the folder same as emulator debugger
The contents of the MCU file (the SFR area, internal RAM area, internal ROM area, the name of
firmware file) are shown below. Change the settings according to the MCU to be debugged. Use your
text editor for changing the MCU file. The parts listed in boldface with an underline are to be changed.
The contents of the MCU file are as follows:
(1) For M302N2FCTGP (M302N2.MCU)
(2) For M302N1M4T-xxxFP (M30217.MCU)
0 : SFR area
3FF :
400 : Internal RAM
17FF
:
E0000
: Internal ROM
FFFFF :
M30620B : Name of firmware (Do not change.)
0 : Expansion No.
0 : SFR area
3FF :
400 : Internal RAM
BFF
:
E8000 : Internal ROM
FFFFF :
M30620B : Name of firmware (Do not change.)
0 : Expansion No.
as emulator debugger M3T-PD30 is stored.
M3T-PD30.
Start address
End address
Start address
End address
Start address
End address
M3T-PD30 V.4.00 or later required (Do not change.)
Start address
End address
Start address
End address
Start address
End address
M3T-PD30 V.4.00 or later required (Do not change.)
( 24 / 38 )