Disable; Delete; Delete All; Go To Source - Renesas Emulator System E8 User Manual

5.4.16

Disable

Disables the selected break channel(s). When a break channel is disabled, a break will not occur
even if specified conditions have been satisfied.
5.4.17

Delete

Initializes the condition of the selected break channel. To retain the details of the break channel
but not have it cause a break when its conditions are met, use the Disable option (see section
5.4.16, Disable).
5.4.18

Delete All

Initializes conditions of all break channels.
5.4.19

Go to Source

Only enabled when one break channel is selected. Opens the [Source] window at address of break
channel.
If an address value has not been set to the break channel, this option cannot be used.
5.4.20

Sequential Conditions

Sets the sequential condition of the break channel.
5.4.21

Editing Break Conditions

Handlings for settings other than PC breakpoints and break conditions are common. The following
describes examples of such handling.
5.4.22

Modifying Break Conditions

Select a break condition to be modified, and choose [Edit...] from the popup menu to open the
dialog box for the event, which allows the user to modify the break conditions. The [Edit...] menu
is only available when one break condition is selected.
5.4.23

Enabling Break Conditions

Select a break condition and choose [Enable] from the popup menu to enable the selected break
condition.
5.4.24

Disabling Break Conditions

Select a break condition and choose [Disable] from the popup menu to disable the selected break
condition. When a break condition is disabled, the break condition will remain in the list, but an
event will not occur when the specified conditions have been satisfied.
84