Table of Contents
Advertisement
• The [Break condition 1] dialog box is displayed.
• Clear the [Don't care] check box in the [Address] group box.
• Select the [Only program fetched address after] radio button and enter H'0E1F2 as the value
in the [Address] edit box.
Figure 6.35 [condition] Page ([Break condition 1] Dialog Box)
Click the [OK] button.
The first point display in the State line changes from Disable to Enable.
The first point display in the Condition line changes from None to Address =
H'0000e1f2(Tutorial.c/41)pcbefore.
Set the program counter value (PC = H'0E6C6) that was set in section 6.8, Setting Registers, in
the [Register] window. Click the [Go] button.
Note: The items that can be set in this page differ depending on the product. For the settings for
each product, refer to the online help.
122
Advertisement
Table of Contents
