Deleting Break Conditions; Deleting All Break Conditions; Viewing The Source Line For Break Conditions; Break Condition X] Dialog Box - Renesas Emulator System E8 User Manual

5.4.25

Deleting Break Conditions

Select a break condition and choose [Delete] from the popup menu to remove the selected break
condition. To retain the break condition but not have it cause an event when its conditions are met,
use the [Disable] option (see section 5.4.24, Disabling Break Conditions).
5.4.26

Deleting All Break Conditions

Choose [Delete All] from the popup menu to remove all break conditions.
5.4.27

Viewing the Source Line for Break Conditions

Select a break condition and choose [Go to Source] from the popup menu to open the [Source] or
[Disassembly] window at the address of the break condition. The [Go to Source] menu is only
available when one break condition that has the corresponding source file is selected.
5.4.28

[Break condition x] Dialog Box

Note: The items that can be set in this dialog box differ depending on the product. For the
R8C/Tiny Series, only the address can be specified.
This page sets the address bus, data bus, and read/write cycle conditions. For R8C/Tiny series,
only address can be specified.
Figure 5.8 [Break condition 3] Dialog Box
85