Renesas Emulator System E8 User Manual page 34

The names of each section of the emulator are explained next.
Emulator Upper-side Panel:
(a) E8 logo plate:
(b) Sliding switch cover: A cover to protect a switch for setting the emulator, which is closed
(c) ACTION LED:
(d) Host connector:
(e) User connector:
Note: Even if the LED is not lit when the emulator is connected to the host computer, the USB is
not malfunctioned.
16
(a)
(d)
(c)
Figure 3.3 Emulator Upper-side Panel
A pink plate dedicated for the emulator is provided to be easily
distinguished from other E-series emulators.
to prevent incorrect operation. Be sure to close this cover during
emulation.
Marked 'ACT'. When this LED is lit, the E8 control software is in
operation.
Marked '
side of this mark.
Marked 'USER I/F'. A connector for the user system interface cable
is provided at the side of this mark.
(b)
'. A connector for the host computer is provided at the
(e)