Connecting The Emulator To The User System - Renesas Emulator System E8 User Manual

3.6 Connecting the Emulator to the User System

Use the procedure below to connect the emulator to the user system with the user system interface
cable, or to disconnect them when moving the emulator or the user system.
1. Check that the host computer is turned off or the emulator is not connected to the host
computer with the USB cable.
2. Connect the user system interface cable to the user-side connector of the emulator.
3. Connect the USB cable to the host-side connector of the emulator.
Figure 3.8 shows the position of the connector.
(1) The connector must be installed to the user system. Table 3.2 shows the recommended
connector for the emulator.
Table 3.2 Recommended Connector
Type Number
2514-6002
Note: When the connector is used, do not install any components within 3 mm of the connector.
Connector for user system interface cable
Figure 3.8 Position of the Connector
Manufacturer
3M Limited
Specifications
14-pin straight type
23