Installing And Removing Pullup Resistors - Renesas Emulation Pod M3062NT3-RPD-E User Manual

3.5 Installing and Removing Pullup Resistors

In this product, you cannot control pullup for ports P0 to P5 by pullup control registers (pullup control
register read/write are possible).
Mounting a pullup resistor inside this product allows pullup control. Mount the 51kΩ resistor array
supplied with this product to the port for which pullup control is required. For the mounting location,
refer to Figure 3.8 below.
Figure 3.8 Position for mounting pullup resistors
Note on Installing and Removing Pullup Resistors:
VCC2 VCC2
P50 P00
P01
P51
P52
P02
P53 P03
P54 P04
P55
P05
P56 P06
P57 P07
• Always shut OFF power before installing or removing pullup resistors. Otherwise,
the internal circuits may be damaged.
• Install pullup resistors properly. Otherwise, the emulation pod will be damaged.
( 37 / 84 )
VCC2 VCC2
P40
P10
P41 P11
P42 P12
P43 P13
P44 P14
P45
P15
P46 P16
P47 P17
CAUTION
VCC2
VCC2
P20 P30
P21
P31
P22 P32
P23 P33
P24 P34
P25 P35
P26 P36
P37
P27