Propeller Sensor Calibration - Bay-Tek Hyper Nova Service Manual

PROPELLER/SENSOR CALIBRATION
To scientifically calibrate the propeller height, you must open the side plexi and place
Then as you play the game, the propeller will spin up to that stop and you can
Tools needed:
5/32" Allen wrench
Blue or Green non-stick Painters Tape
Instructions:
Open one of the plexi side panels by removing the 5 bolts using a
5/32" Allen wrench.
Important: Only reach into the propeller area before or after hours
to ensure a guest does not coin up the game and try to play.
Be very aware that the propeller spins very fast and may cause in-
jury if misused.
Raise the propeller up by hand and position in the middle of one of
the large ticket bonus locations.
Wrap the non-stick painters tape around the shaft directly above
the propeller assembly.
This will stop the propeller in the exact middle of the ticket area
when the game is played.
Coin the game up and push the handle hard and the propeller will
stop at the painters tape.
The game will then place a red arrow on the display.
If the arrow is not placed in the correct position, enter the menu
and go to the calibration mode for that section.
(Either lower, middle or upper)
If arrow is too high, reduce the value in the menu.
If the arrow is too low, increase the value in the menu.
Do this same process for all 3 of the large ticket bonus locations.
a physical stop on the shaft.
adjust the placement of the win arrow in the game menu.
45