Reset Break-In - Quicksilver SmartCraft Systems Reference Manual

2.0 Marine Diagnostics

RESET BREAK-IN

Using the RESET BREAK-IN function, you can reprogram the ECMs
factory break-in oil mode.
IMPORTANT: In the event that a new powerhead is installed you
must reset the oiling routine.
Make sure that the SELECT FUNCTION menu screen is displayed on
the DDT. Press the 4 key.
The RESET BREAK-IN OIL screen will appear. Press 1 key.
NOTE: The reset mode will clear all fault and run history counters,
followed by a complete oil pump prime cycle.
Press
Available
To EXIT
90
1- Mercury Marine
Select Function:
1-OIL PUMP PRIME
2-CYLINDER MISFIRE
3-OUTPUT LOAD TEST
4-RESET BREAK-IN
RESET BREAK-IN OIL
WILL PRIME THE OIL
PUMP AND CLEAR ALL
HISTORIES. 1=YES 2=NO
Press the1 key.
RESET BREAK-IN OIL:
PRESS 1 TO START
PRESS 2 TO CANCEL
Press the1 key.
PLEASE WAIT
RESET IN PROGRESS . . .
THIS MAY TAKE A FEW
MINUTES TO COMPLETE.
Press the1 key.
BREAK-IN OILING HAS
BEEN REACTIVATED,
PROGRAM SUCCESSFUL.
PRESS MODE TO EXIT.
5 SPECIAL FUNCTIONS
Reference Manual