Table of Contents
Advertisement
2.0 Marine Diagnostics
PLEASE WAIT READING
ECM DATA.....
If there is data stored in the Freeze Frame buffer, a menu list is
displayed which actually identifies the fault that triggered the freeze
frame event.
Make sure the FREEZE FRAME menu screen is displayed on the
DDT.
FREEZE FRAME BUFFERS
0-BREAK-IN
1-DINJ6 OPEN
2-PORT OVERHEAT
Press the 1 key. Direct Injector 6 or its connection triggered this event.
You will now be able to view engine system data at the exact time the
fault was recorded.
DINJ 6 OPEN
BARO PSI
BATT VOLTS
BLOCK PSI
BOAT SPEED
AIR TMP _F
COOL TMP _F
DEMAND %
ENGINE RPM
ENGINE STATE STALL
FPC TOTAL
FREQ COUNTER
NOTE: Not all parameters are available on all engine models. See
glossary for further descriptions of data labels.
PRINT
Press
To EXIT
Press F2, 1
50
1- Mercury Marine
The barometric pressure when the fault occurred.
14.1
14.6
The battery voltage when the fault occurred.
5.3
The engine block pressure when the fault occurred.
0.0
Boat speed when the fault occurred.
78.8
The engine temperature when the fault occurred.
127
The primary (CTS) coolant temperature when the fault occurred.
0.0
The Demand %( TPI%) when the fault occurred.
0
The engine RPM when the fault occurred.
The engine state when the fault occurred.
12.7
The calibrated fueling level when the fault occurred.
0
The number of times the fault occurred. 0=1 occurrence,
1=2 occurrence
4 HISTORY
or
FREEZE FRAME BUFFERS
NO STORED FAULTS
PRESS MODE TO EXIT
Reference Manual
Advertisement
Table of Contents
