Table of Contents
Advertisement
2.0 Marine Diagnostics
You can use the Fault Status function to display the active or history
status of ignition, injectors, pumps, sensors, switches, miscellaneous
items, limit modes or break-in status.
Make sure that the SELECT FUNCTION menu screen is displayed on
the DDT.
FAULT STATUS has been organized in a way by which all faults can
be viewed from a single display area. For example: if a sensor fault
occurs while connected to the ECM, LED 4 will light.
All LED (1–8) supported faults will be displayed in the FAULT STATUS
display area. When a fault is currently active the YES message will
appear. If the fault corrects itself while the user is still connected to the
ECM, the message will change to NO. The message No would
indicate that a past history event occurred with that specific device. NO
is usually an indication of an intermittent connection problem. Faults
are also stored in the Freeze Frame buffers. See the section on Freeze
Frame for more details. If there are no faults active, the message
NONE will be displayed in the FAULT STATUS screen.
PRINT
Press
To EXIT
Press F2, 1
46
1- Mercury Marine
Select Function:
1–DATA MONITOR
2–FAULT STATUS
3–SYSTEM INFO
Press the 2 key
FAULT
BREAK–IN
STAR OVERHEAT
MAP INPUT LO
FAULT
NONE
2 FAULT STATUS
ACTIVE
YES
NO
YES
ACTIVE
Reference Manual
Advertisement
Table of Contents
