Table of Contents
Advertisement
When all 51 frames of data have been recorded, the r displayed in the
lower right hand corner of the screen will change to an upper case R
(underlined).
R = Recording complete.
To save the frames of data that have been captured, press the MODE
key. This will automatically take you to the Data Capture Screen. When
the Data Capture screen appears, press 1 –YES to save data.
Press the YES key if you want the data to be saved to a file. The
following screen will appear.
You may enter any file name up to eight characters in length. To name
the file, press a number key from 0 to 9 to select a number. Press the
key and press a number from 0 to 9 to select the letters A to J.
Press the
key to display the letters K to T and again to see the letters
U to Z.
Press the
key to display the previous set of letters.
When you have entered the file name, press the ENTER key.
Reference Manual
RECORD/PLAYBACK
ENGINE RPM
TPI 1 VOLTS
BATTERY VOLTS
PWR 1 VOLTS
Data Capture:
SAVE RECORDED DATA?
Press 1-YES 2-NO
Save as:
__________.DMO
0123456789
0123456789
1.0 Introduction
690 <E
0.59
13.5
5.0
R
19
Advertisement
Table of Contents
