Using Other Serial Printers - Quicksilver SmartCraft Systems Reference Manual

USING OTHER SERIAL PRINTERS

Requirements for other printers
1 The printer must have a serial data protocol with x–on/x–off
handshaking.
2 There is a tool–to–printer cable available. The cable must be
configured as shown:
DB–25
2–TXD (Host out)
3–RCV (Host in)
7–Ground
3 The printer can have a baud rate of 300, 600, 1200, 2400, 4800,
or 9600.
4 The printer must have one or two stop bit capability.
(The DDT defaults to 2400 baud rate and one stop bit.)
Reference Manual
1.0 Introduction
15