Run History - Quicksilver SmartCraft Systems Reference Manual

2.0 Marine Diagnostics

RUN HISTORY

NOTE: Run Time is displayed in hours unless otherwise specified.
The sum of the individual times may not always add up to the total
ECM run time if the history was previously cleared. Time spent at each
point must be at least 1 minute to be logged in history after which the
time is updated every 6 (0.1 hour) minutes to the screen.
Press the MODE key to return to the SELECT FUNCTION menu.
Make sure that the SELECT FUNCTION menu screen is displayed on
the DDT. Use the
Press the 4 key. The SELECT FUNCTION screen will appear.
Press the 2 key. The HISTORY screen will appear. Use the
display the additional screens and the
screen.
RUN TIME HR.
RPM 0-749
RPM 750-1499
RPM 1500-2999
RPM 3000-3999
RPM 4000-4499
RPM 4500-4999
RPM 5000-5499
RPM 5500-6249
RPM 6250+
BREAK-IN LEFT
RPM LIMIT Sec
Press the MODE key to return to the Select Fault History menu.
54
1- Mercury Marine
key to display the additional screens.
Select Function:
2-FAULT STATUS
3-SYSTEM INFO
4-HISTORY
5-SPECIAL FUNCTIONS
Select Function:
1-FAULT HISTORY
2-RUN HISTORY
3-CLEAR FAULT HIST
4-CLEAR RUN HIST
16.5
0.3
1.4
10.9
1.0
2.5
0.4
0.0
0.0
0.0
0
38
4 HISTORY
to return to the previous
GRD LIMIT Sec
ACT TEMP Sec
BLOCK PSI Sec
CTS TMP Sec
CTP TMP Sec
LOW OIL Sec
OIL PMP Sec
PRINT
Press F2, 1
key to
0
0
0
0
0
0
0
Press
To EXIT
Reference Manual