Table of Contents
Advertisement
2.0 Marine Diagnostics
POWER UP
NOTE: If the display is blank:
– engine switch is off
– the interface and/or adaptor cables are not properly connected
1
Insert the software cartridge into the DDT, making sure the label
is facing up. You should feel it click into place if done correctly.
2
Set the engine key to RUN or ON position.
3
A power-up screen will be displayed while the DDT performs a self
test.
After the copyright screen appears, the SmartCraft monitor screen will
appear. Select 1 - Mercury Marine.
4
The DDT will attempt to communicate with the ECM. If it cannot,
a NO RESPONSE screen will be displayed.
If the DDT can communicate with the ECM, the next screen displayed
will indicate the model year, displacement and horsepower.
32
1-Mercury Marine
SmartCraft Monitor
1-Mercury Marine
2-Tool Setup
No ECM response
Check connector
and key position
Press MODE
THIS ENGINE IS A
01 MY DFI 2.5L 175
PRESS 1 TO CONTINUE
Reference Manual
Advertisement
Table of Contents
