Table of Contents
Advertisement
1.0 Introduction
Overview
Use this function to select the DDT baud rate and the number of stop
bits. You can also save the Tool Setup or restore the previously saved
setup.
Make sure the SELECT FUNCTION Menu screen is displayed on
the DDT.
Press the 2 key. The TOOL SETUP MENU screen will appear.
General Setup
TO SET THE DDT:
From the TOOL SETUP MENU, press the 1 key. The GENERAL
SETUP screen will appear.
Use the
and
on the line you wish to change, use the
options. Option choices are listed in the table below.
Parameter
Baud
Stop Bits
Once the selected choice is made, then press MODE to exit. From the
TOOL SETUP MENU select 2 if you wish to save the setup. Follow the
instructions on the screen. When the settings are saved press MODE
to return to the SMARTCRAFT MONITOR screen.
16
TOOL SETUP
Main Menu
SmartCraft Monitor
1-Mercury Marine
2-Tool Setup
TOOL SETUP MENU
1-General Setup
2-Save Setup
3-Restore Setup
PRN BAUD
STOP BITS
keys to scroll the cursor. When the cursor is located
Options
300, 600, 1200, 2400, 4800, 9600
1 or 2
2400
1
and
keys to change the
Reference Manual
Defaults
2400
1
Advertisement
Table of Contents
