Direct Injector Load Test - Quicksilver SmartCraft Systems Reference Manual

DIRECT INJECTOR LOAD TEST

Using the OUTPUT LOAD TEST function, you can exercise the ECM
and various output loads (ignition coils, injectors, pumps, horn, etc.)
controlled by the ECM.
Make sure that the SELECT FUNCTION menu screen is displayed on
the DDT. Press the 3 key.
The SELECT LOAD TEST screen will appear.
This test is run with key switch in run position only (engine off). To test
the direct injector for mechanical activity press the 3 key.
DISONNECT POWER
TO HIGH PRESSURE
FUEL PUMP
PRESS 1 TO CONTINUE
LISTEN FOR INJECTOR
OPENING AND CLOSING
DURING THIS TEST.
CONTINUE? 1=YES 2=NO
NOTE: This test will run automatically once the user has entered a
cylinder number to test.
Reference Manual
2.0 Marine Diagnostics
1- Mercury Marine
Select Function:
1-OIL PUMP PRIME
2-CYLINDER MISFIRE
3-OUTPUT LOAD TEST
4-RESET BREAK-IN OIL
Select Load Test:
1-IGNITION
2-FUEL INJECTOR
3-DIRECT INJECTOR
Press the1 key.
Press the1 key.
5 SPECIAL FUNCTIONS
ENGINE ISN'T RUNNING
DURING THIS TEST.
PRESS 1 TO CONTINUE
PRESS MODE TO CANCEL
Press the1 key.
SELECT CYL TO TEST:
1 2 3 4 5 6 7 8
PRESS MODE TO CANCEL
Press the1 key.
Press
To EXIT
Available
67