Table of Contents
Advertisement
1.0 Introduction
a-Printer Power Plug
b-DB-25 Printer Cable
NOTE: The OTC serial printer (part number 3315, which has a 2400
baud rate) or OTC Hi Speed Serial printer (part number 3285, which
has a 9600 baud rate) is recommended if a printer is desired.
1
Connect power to the printer by using one of the following
methods:
a. Insert the printer's power plug into the battery adapter cable and at-
tach the battery adapter cable to the battery.
b. Insert the printer's power plug into a cigarette lighter receptacle.
2
Connect the DB–25 printer cable between the DDT's serial
interface and the printer.
3
Turn the printer power switch On.
4
Set the DDT stop bit and baud rate as described in the section
of this manual titled, Tool Setup.
5
The printer will be ready to print once you have completed and
saved the setup. To begin printing, press F2, then 1 or press F2,
then 9 to display the File Manager screen. While printing, the
DDT ignores all commands (except the MODE key) and shows
"PRINTING."
6
To stop a printout, press the MODE key. A few more lines may print
while the printer memory is clearing.
You can print almost any time that data from the engine is being
displayed. A screen that does not display data, such as the Injector
Test, does not allow printing.
14
PRINTER SETUP
a
b
or
Reference Manual
Advertisement
Table of Contents
