Table of Contents
Advertisement
NOTE: SYSTEM INFO includes typical ranges for sensors and
output devices for the specific ECM.
Using the SYSTEM INFO function, you can display the ID of the
engine, ECM, Calibration, Engine version as well as component specs
which are stored in the ECM.
Make sure that the SELECT FUNCTION menu screen is displayed
on the DDT.
Press the 3 key. The SYSTEM INFO screen will appear.
Press the MODE key to return to the SELECT FUNCTION menu.
The screens below are an example of how screens will appear.
01 MY DFI 175
ECM # 859610–4
CODE 878086–4
IGN PRI .38-.78 ohm
SEC 8.1-8.9 Kohm
DINJ 1.0-1.6 ohm
FINJ 1.7-1.9 ohm
TYPICAL TPI RANGE
TPI1 0.19 – 1.0v IDLE
PRINT
Press F2, 1
Available
Reference Manual
2.0 Marine Diagnostics
1-Mercury Marine
Select Function:
1-DATA MONITOR
2-FAULT STATUS
3-SYSTEM INFO
3.45 – 4.63V WOT
Press
To EXIT
3 SYSTEM INFO
TGAP 0.025 – 0.04 in.
PWR RLY 81 – 99 ohm
RPM LIMIT 5850
PROP RPM 5250 –5750
AIR COMPRESSOR
1 Kohm @ 77_F/25_C
AIR TEMP/COOLANT
10 Kohm @ 77_F/25_C
MORE INFO AVAILABLE
MAY VARY BY MODELS
47
Advertisement
Table of Contents
