2D Matrix Symbologies; Aztec Code; Aztec Code Defaults; Aztec Code On/Off - Novanta JADAK FM-8 User Manual

2D Matrix Symbologies

Aztec Code

Aztec Code Defaults

To set the default values for Aztec Code, scan this code:

Aztec Code On/Off

Scan one of the codes below to enable or disable Aztec Code. Default = Enabled.
* Enable

Aztec Code Minimum and Maximum Length

Use the following commands in combination with numerical values to set the minimum
and maximum length for allowed Aztec barcodes.
Default minimum length = 1. Default maximum length = 3832.
The minimum and maximum length for this symbology can be set either by sending the
serial command shown under the barcodes below with a value between 1 and 3832, or
by scanning one of the barcodes below and then set the length by scanning the digit
codes and the SAVE barcode in
Please contact JADAK if assistance is needed.
Aztec Code Minimum length
JADAK FM-8/FM-9 User's Manual
Appendix B
.
Disable
Aztec Code Maximum length