Data Matrix; Data Matrix Defaults; Data Matrix On/Off; Data Matrix Minimum And Maximum Length - Novanta JADAK FM-8 User Manual

Data Matrix

Data Matrix Defaults

To set the default values for Data Matrix, scan this code:

Data Matrix On/Off

Scan one of the codes below to enable or disable Data Matrix. Default = Enabled.
* Enable

Data Matrix Minimum and Maximum Length

Use the following commands in combination with numerical values to set the minimum
and maximum length for allowed Data Matrix barcodes.
Default minimum length = 1. Default maximum length = 3116.
The minimum and maximum length for this symbology can be set either by sending the
serial command shown under the barcodes below with a value between 1 and 3116, or
by scanning one of the barcodes below and then set the length by scanning the digit
codes and the SAVE barcode in
Please contact JADAK if assistance is needed.
Data Matrix Minimum length
JADAK FM-8/FM-9 User's Manual
Appendix B
.
Disable
Data Matrix Maximum length