Code 93; Code 93 Defaults; Code 93 On/Off; Code 93 Minimum And Maximum Length - Novanta JADAK FM-8 User Manual

Code 93

Code 93 Defaults

Set all Code 93 settings to their default configuration with this code.

Code 93 On/Off

Scan one of the codes below to enable or disable Code 93. Default = Enabled.
* Enable

Code 93 Minimum and Maximum Length

Use the following commands in combination with numerical values to set the minimum
and maximum length for allowed Code 93 barcodes.
Default minimum length = 0. Default maximum length = 55.
The minimum and maximum length for this symbology can be set either by sending the
serial command shown under the barcodes below with a value between 0 and 55, or by
scanning one of the barcodes below and then set the length by scanning the digit codes
and the SAVE barcode in
Please contact JADAK if assistance is needed.
Code 93 Minimum length
JADAK FM-8/FM-9 User's Manual
Appendix B .
Disable
Code 93 Maximum length